With the development of deceleration motor, it brings convenience to production and life, and more and more people analyze and study the motor. There are certain requirements for the disassembly and assembly of the decelerating motor. How to disassemble and assemble the motor? Next, the Wonsmart motor deceleration motor factory introduces the dismantling and assembling process of the motor.

(1)Remove the external wiring of the motor and mark it first. Then release the foot screws and separate the motor from the transmission machinery.

(2)To remove the pulley or coupling on the motor shaft, it is sometimes necessary to add kerosene into the gap between the motor shafts of the pulley to make it permeable and lubricated for easy disassembly.

(3)For motors with rolling bearings, the outer cover of the bearing should be removed first, then the fastening screw of the end cover should be loosened, and the mark should be made at the joint between the end cover and the housing. The screw of the tightening end cover should be screwed into two special holes on the end cover of the motor and the end cover should be ejected.

(4)When disassembling a deceleration motor with a brush, the brush should be removed from the grip of the brush, and the position of the neutral line of the brush should be marked for the DC motor.

(5)When pulling out the rotor, we must pay attention not to touch the stator coil. If the rotor weight is not large, it can be pulled out by hand; if the rotor weight is large, it should be lifted by lifting equipment. First, the two ends of the rotor shaft are set up for reusing the wire rope to hoist the rotor with lifting equipment.